WAGNER CONTROL SPRAY QX5 User Manual

10
EN
CLEANUP
CLEANUP NOTES
i
When cleaning, use the appropriate cleaning
solution (warm, soapy water for water-based
coatings, and mineral spirits for oil-based
coatings.
Special cleanup instructions for use with
ammable solvents (must have a ashpoint
above 100ºF (38ºC):
• Always ush spray gun outside.
• Area must be free of ammable vapors.
• Cleaning area must be well-ventilated.
• Do not submerge turbine!
i
For basic quick-cleaning between color changes,
ll the material container with cleaning solution
and spray the cleaning solution through the
gun and into a waste container.
1. Turn turbine OFF. Separate the turbine from the nozzle.
Remove the container and empty any remaining material.
Thoroughly rinse the material container with warm, soapy
water (or mineral spirits for oil-based materials).
2. Disassemble the spray gun and clean all parts with warm soapy
water (or mineral spirits for oil-based materials).
Reassemble all parts when clean.
3. Clean the air vent (a) on the suction tube with a soft bristled
cleaning brush.
4. Clean the rear of the nozzle (b) with the appropriate cleaning
solution. Use a thin layer of petroleum jelly to lubricate the
O-ring (c).
i
For a video showing cleanup of the Control Spray QX5, visit:
www.wagnerspraytech.com/controlsprayQX5
1
2
3
(a)
4
(b)
(c)

WAGNER CONTROL SPRAY QX5 Specifications

General

Brand	WAGNER
Model	CONTROL SPRAY QX5
Category	Paint Sprayer
Language	English