MATERIAL PREPARATION
1
2
3
6
EN
TO PREPARE THE MATERIAL
1. Stir the spraying material thoroughly.
2. Unscrew the cup from the nozzle.
3. After the material has been properly thinned* and strained,
ll the container to desired level.
*THINNING THE MATERIAL
For certain spraying situations or desired nishes, thinning the
material may be desired. It is not necessary for most materials
when used with the iSpray nozzle. For use with the Detail Finish
nozzle thinning may be needed to achieve a ner nish. Make
sure you adjust the X-Boost™ and Material ow settings for your
specic material needs.
If thinning is necessary, use water for water-based materials,
mineral spirits for oil-based materials. Never exceed the
thinning advice given by the coating manufacturer.
Do not thin with materials that have a
ashpoint below 100°F (38°C).
Material to be sprayed may need to be strained to remove any impurities in the paint which may enter and
clog the system. Impurities in the paint will give poor performance and a poor nish.
Thinning the material may be necessary but only after attempting to achieve optimal spray performance by
adjusting the various controls.
To Next Page
Loading...
Need help?
General
