English
10 © Wagner Spray Tech. - All Rights Reserved
Cleanup
IMPORTANT: Make sure your floors and
furnishings are covered with drop cloths
during cleanup.
You will need:
• A waste container
• A minimum of one gallon of warm, soapy
water if you used latex paints
• A minimum of one quart of mineral spirits if
you used oil-based paints
IMPORTANT: DO NOT SUBMERGE THE
ROLLER HANDLE INTO ANY LIQUIDS!
Notes:
• Thoroughly cleaning your unit and its
components is the best way to ensure the
prolonged life of your unit.
• A light paint lm residue may remain in the
paint hose after cleaning. This is normal and
will not aect the future performance of your
unit.
• Switch the unit OFF (0) prior to removing any
accessories or components.
• A Roller Cleanup Kit™ is available for separate
purchase. See Accessories, page 44 for
ordering information.
To Clean:
1. Submerge suction tube into a bucket of the
appropriate cleaning solution.
2. Press locking tab and drop roller cover
assembly into a bucket of the appropriate
cleaning solution.
3. Place the roller arm in the material container
in order to catch paint.
4. Turn the switch ON. Fully press and release
the handle button to switch the motor on.
Let the motor run for 15 seconds to push
paint from the hoses back into the paint can.
Fully press and release the handle button to
switch the motor o.
Scan this QR code with your
mobile device and you will be
directed to a video on Cleanup
tips.
1
2
4
3
PRESS
15 SECONDS
To Next Page
Loading...
Need help?
General
