Correction of Malfunctions
Problem Cause Remedy
Spray gun buzzes
and does not work
Piston stuck
•
Defective drive
•
Disassemble pump and ➞
clean with thinner
Send spray gun to ➞
customer service center
Spray gun does not
suck in
No valve in the pump
•
Suction tube loose in the
•
conical bore
Venting hole in pump housing
•
clogged
Intake hole (tting) in
•
pumphousing logged
Viscosity of spray material too
•
high
Insert valve ➞
Adjust suction tube ➞
Clean ➞
Clean ➞
Thin accordingly ➞
Spray gun sucks in
but does not spray
Nozzle clogged
•
Ducts and holes in atomiser
•
clogged
Clean ➞
Clean ➞
Spray gun works but
sprays unevenly
Spray material in container
•
running out
Spray gun held inclined
•
leading to sucking in of air
Viscosity of spray material too
•
high (too thick)
Fine adjustment button not
•
set correctly
Wrong nozzle size
•
Nozzle worn out
•
Valve worn out
•
Wrong valve inserted
•
Rell ➞
Use exible nozzle ➞
extension (see accessories)
Dilute accordingly ➞
Reset according to spray ➞
material
Change nozzle ➞
Replace ➞
Replace ➞
Use correct valve ➞
Environmental protection
The appliance and accessories should be recycled in an environmentally
friendly way. Do not dispose of the appliance with household waste. Support
environmental protection by taking the appliance to a local collection point or
obtain information from a specialist retailer.
Important Note regarding Product Liability!
Due to an EC ordinance in eect since 01.01.1990, the manufacturer is liable for his product
only if all parts originate from or were approved by the manufacturer and the devices
are assembled and operated correctly. The use of other accessories and spare parts can
partially or completely invalidate the liability.
To Next Page
Loading...
Need help?
General
