GB
29
W 890 Flexio
4. Remove the spray attachment from the deposition tray. Unscrew the container from
the spray attachment.
5. Align the ascending tube. (Fig. 5)
If the ascending tube is positioned correctly, the container contents can be sprayed
without almost any residue. When working on lying objects: Turn the ascending
tube forwards. (Fig. 5A)
Spraying work when working on overhead objects: Turn the ascending tube
rearwards. (Fig. 5B)
i
For easier coating of ceilings and lying objects, we recommend the 60 cm
Universal Extra Extension. (Order no. 2361756)
6.
Place the container on a paper base and ll in the prepared coating material.
Screw the container rmly onto the spray attachment.
7. Connect the front part of the gun and the gun handle to each other. (Fig. 6)
8. Close the device cover and pull the carry handle upwards. This makes the gun holder
accessible.
9. Put the spray gun onto the gun holder at the device.
10. Place the device only on a plane and clean surface. Otherwise, the gun may suck in
dust, etc.
11. Switch on the main switch at the device (Fig. 1, item 14).
12. Remove the spray gun from the gun holder and point it at the object to be coated.
13. Press the On/O switch at the gun handle (Fig. 7, item 2).
i
The enclosed practice poster is ideal for familiarising yourself with
operation of the spray gun. After trying out the rst spray coatings, it
makes sense to test it further on cardboard or a similar surface in order
to nd out the right ow rate of paint and air for the best spray pattern.
Detailed information about these settings can be found in chapter
11-15.
17. Setting the Amount of Air (Fig. 7, item 1)
Depending on the viscosity of the material to be sprayed and the nish of the object
to be coated, it may be advisable to vary the amount of air. Very low viscosity materials,
such as watery glazes do not have to be atomised with the maximum amount of air. In
this case it is advisable to reduce the amount of air and thus minimize the spray vapour.
This also applies for the use of the Detail and Corner&Reach spray attachment (accessory).
- turn to the left lower amount of air
+ turn to the right higher amount of air
To Next Page
Loading...
Need help?
General
