EasyManuals Logo
Home>WAGNER>Paint Sprayer>W 890 FLEXIO

WAGNER W 890 FLEXIO User Manual

WAGNER W 890 FLEXIO
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
GB
34
W 890 Flexio
Assembly
Attention! Never operate the device if the nozzle seal is either damaged or
missing. If the nozzle seal is either missing or damaged liquids can enter
the device and increase the risk of an electric shock.
1) Check the nozzle seal (g. 20, 4) in the nozzle.
2) Screw the union nut (Fig. 21, 2) onto the gun and tighten it.
Tighten the union nut (Fig. 21, 2) fully so that no paint is able to penetrate
the device.
3) Engage the air cap (Fig. 22, 1) with the union nut. Check if the air cap has properly
locked into place on both sides. (Fig. 22, 2)
4) Place the container seal from below on the suction tube and slide it over the collar,
while turning the container seal slightly.
5) Insert the suction tube with container seal in the gun body.
In order to mount the gun more easily apply lubricating grease (enclosed) liberally to
the O-ring at the spray attachment (Fig. 25, 3) and to the O-ring of the plug connection
of the air hose (Fig. 26, 2).
21. Maintenance
Air lter
WARNING! Never operate the machine without the air lter; dirt could
be sucked in and interfere with the function of the machine.
Do not store any objects in the air lter compartment.
Disconnect plug before changing parts.
Change the air lter if it is soiled. Unplug the power plug. Open the cover of the air
lter compartment (Fig. 23). Insert a new air lter into the compartment. Close the
cover of the air lter compartment.
Ventilating hose / Valve
1) Pull the ventilating hose (Fig. 16, A) at the top from the gun body. Screw o the valve
cover (B). Remove the diaphragm (C). Carefully clean all parts or replace in the
event of damage.
2) Place the diaphragm (Fig. 16, C) with the pin facing upwards on the bottom section
of the valve. Also see the marking on the gun body.
3) Place on the valve cover (Fig. 16, B) and screw it closed.
4) Place the ventilating hose (Fig. 16, A) on the valve cover and on the nipple at the gun
body.
22. Storage
Remove the hose and when storing it in the cover put in the gun handle rst.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the WAGNER W 890 FLEXIO and is the answer not in the manual?

WAGNER W 890 FLEXIO Specifications

General IconGeneral
BrandWAGNER
ModelW 890 FLEXIO
CategoryPaint Sprayer
LanguageEnglish

Related product manuals