39
W 950 Flexio/ W 975 Flexio
General
Wall paint
39
W 950 Flexio/ W 975 Flexio
EN
8. Preparation of the Coating Material
Mix the material well in the original container. When using interior wall paint, an agitator
is recommended.
i
W 950 / W975 has been developed for use with all conventional paints in their
undiluted form. If the surface is smooth and the paint you are using is very thick
and gel-like, dilute it by 10%. Dilution can be necessary if the atomisation is
coarse or if the ow rate is too low even at the maximum setting.
Detailed information about the various materials and the maximum permitted
dilution can be found on the manufacturers' technical data sheets (e.g. available
on the Internet).
i
Spray material that is at least at room temperature provides a better spray
result.
i
The following chapters 9-19 discuss using the W 950 / W975 as a wall paint
spraying system.
Read chapters 20-26 if you want to use varnish paints and glazes with the
W 950 / W975.
9. Preparation of the workplace (for interior wall paint)
Sockets and plugs must be masked. Risk of an electric shock as a
consequence of sprayed material entering the socket!
Mask all the areas and objects that are not to be spray painted, or
remove them from the work area. No liability is assumed for damage
due to overspray. Silicate paint corrodes glass and ceramic surfaces
upon contact! All such surfaces must therefore be completely covered.
i
Pay attention to the quality of the adhesive tape used.
Do not use excessively strong adhesive tape on wallpaper and painted
surfaces, in order to avoid damaging these surfaces when removing the
tape. Remove adhesive tape slowly and evenly; do not use jerky movements.
Do not leave adhesive tape on surfaces any longer than necessary, in order
to minimise the possibility of residues when removing.
Also observe the adhesive tape manufacturer's instructions.
To Next Page
Loading...
Need help?
General
