11
Waves Nx Head Tracker – User Guide
4)
Once the Nx Head Tracker’s firmware is updated to 1.19v1.13, turning off
the device (long button press) will put the device in sleep mode (indicated
by the LED flashing red). In this mode, the battery should last over six
months.
During the update, try not to handle the device; leave it stationary on a flat surface. You
can update only one Nx Head Tracker device at a time.
While the device is updating, make sure that no other system is using the Waves
HeadTracker application in close proximity. Two nearby systems using the application
at the same time can interfere with each other.
We advise that you start the firmware update with a full battery. If the battery
is too low, there is a slight risk that the update process will fail in a way that
will make the device unusable. The application has a safety threshold that will
not let the update process start when the battery is too low, but using a full
battery is still advised when updating. If your Nx Head Tracker becomes
inoperable after a firmware update, please contact our technical support team
at http://www.waves.com/contact-us.
To Next Page
Loading...
General