EasyManuals Logo
Home>Webster>Burner>JB Series

Webster JB Series User Manual

Default Icon
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
(1) STANDARD UL
EQUIPMENT
AND IMPORTANT OPTIONS
Gas
No. 2 Oil
No. 4 - 6 Oil
Air Atomized
STANDARD UL EQUIPMENT
AND IMPORTANT OPTIONS
Gas
No. 2 Oil
N0. 4 - 6 Oil
Air Atomized
Pressure
Atomized
Air
Atomized
Pressure
Atomized
Air
Atomized
General
Motor, Fan and Air Inlet Control X X X X
Gas Fuel
Main Manual Shutoff Valve X
Air Flow Switch X X X X Main Safety Shutoff Valve X
(2) Burner Mounted Control Panel,
Switch and Four Indicator Lights
X X X X
Second Safety Shutoff Valve X
Main Gas Regulator X
Flame Safety Control X X X X Gas Checking Valve X
Ultra Violet Scanner X X X X High and Low Gas Pressure Switches X
Motor Starter with Overloads X X X X Metering Valve (modulating systems) X
Fuel Selector Switch Duel Fuel Burners Only Normal Open Vent Valve (above
12,500 MBH)
X
Ignition
Proven Gas Pilot Ignition X X X
Oil Fuel
Oil Drawer Assembly with Diffuser X X X
Pilot Solenoid Gas Valve X X X Oil Nozzles X X X
Pilot Gas Regulator & Manual Valve X X X Oil Heater with Integral Thermostat X
Pilot Gas Ignition Transformer X X X Remote Oil Pump X Opt. Opt.
Two Safety Shutoff Valves X X X
High Oil Temperature Switch X
Low Air Atomizing Switch X
Options
Inverted Housing X X X X Low Oil Pressure Switch X X X
Alternate Control Cabinet Positioning X X X X Oil Pressure Gauge X X X
Remote Control Panel X X X X Oil Metering Valve X X X
Fuel Metering CAM-NETIC II X X X X Future Gas Combustion Head Opt. Opt. Opt.
Posi-Control X X X X Air Compressor X X
1. The configuration of each unit will vary with specific job requirements such as input rating, electrical specification and special agency approval codes.
The above chart shows those items standard to a basic burner plus a few options that may be added.
2. Indicator lights are “Power On”, “Call for Heat”, ”Fuel On” and ”Flame Fail”.
Model JB3 - Sizing and Application Data (contact Webster for complete information)
Model
Number
Maximum
Furnace
Pressure
Burner Firing Capability Range Burner
Motor
HP
Gas Train #2 Oil Pump Motor HP #4 - 6
Pump
Motor HP
Air
Compressor
Motor HP
Pipe
Size
Inlet
Press
Pressure
Atomizing
Air
Atomizing
Gas scfh #2 Oil
gph
#4-6
Oil gph
JB3-30 3.5 1400 / 6300 10.2 / 45 10 / 42 3 2 1/2” 12 / 27” 1 Optional Optional 2
JB3-50 3.5 1400 / 8300 11 / 59.2 10 / 55.3 5 3” 15 / 27” 1 1/2 Optional Optional 2
JB3-75 3.5 1600 / 10500 12.3 / 75 11 / 70 7 1/2 3” 23 / 27” 1 Optional Optional 2
JB3-100 3.5 1800 / 12600 20.3 / 90 12 / 84 10 3” 2-5 psi 1 Optional Optional 2
The above maximum ratings are based on 0 furnace pressure, an altitude of 1000 feet, 90
o
F air temperature and 60 HZ electrical supply. Use the follow-
ing corrections for higher temperatures and altitude. Capacity by 17% for 50 Hertz.
Capacity decreases by 4% for each 1000 feet above 1000 foot altitude.
Capacity decreases by 6% for each 1 inch of furnace pressure.
Capacity decreases by 2% for each 10
o
F increase in air temperature over 90
o
F.
Gas input ratings based on 1000 BTU/cu ft. and 0.64 specific gravity. Sizes and pressure will vary with gas.
Oil input ratings are based on 140,000 BTU/gal. for ASTM #2 fuel oil and 150,000 BTU/gal for ASTM #4-6 fuel oil.
The vessel draft must be between -0.1 and +0.1 wc.
Essential Ordering Information and Data:
Power Supply - Confirm 120-60-1 for control circuit and electrical supply for burner motor(s) (voltage, frequency and phase).
Describe Boiler or Heater to be Fired - Including the manufacturer, model number, furnace pressure and furnace size.
Firing Rate - Define firing rates in MBH for gas and GPH for oil.
Fuel to be Burned - Type of gas and/or oil, including the BTU value.
Approval Agency - UL, FM, IRI (GE GAP), CSD-1, NFPA, Mil spec and local codes, if applicable.
Flame Safety Control Preferred - Honeywell or Fireye controls.
Gas Train Components Preferred - ASCO/ITT, Honeywell or Landis
Control System - ON-OFF, Low Fire Start, Low High Low, Modulation, Posi-Control
Required Options - Mounting plate, operating controls, limit controls, etc.
Model JB3 - Specification Data (12,600 MBH Maximum Input)
Page 10
SpecificationJB Manual

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Webster JB Series and is the answer not in the manual?

Webster JB Series Specifications

General IconGeneral
BrandWebster
ModelJB Series
CategoryBurner
LanguageEnglish

Related product manuals