15
ATTACHING THE LEG LEVER TO THE LOW
PULLEY STATION
To use the Leg Lever (20), the seat must be attached
to the front upright (see ATTACHING AND REMOV-
ING THE SEAT on page 14). Attach the Chain (58)
between the Low Cable (70) and the 5/16” x 2” Eye
Bolt (21) with two Cable Clips (57).
ATTACHING THE LAT BAR OR NYLON STRAP TO
THE LOW PULLEY STATION
Attach the Lat Bar (60) to the Low Cable (70) with a
Cable Clip (57). For some exercises, the Chain (58)
should be attached between the Lat Bar and the Long
Cable with two Cable Clips. Adjust the length of the
Chain between the Lat Bar and the Low Cable so
the Lat Bar is in the correct starting position for
the exercise to be performed.
The Nylon Strap (59) can be attached in the same
manner.
ATTACHING THE LAT BAR OR NYLON STRAP TO
THE HIGH PULLEY STATION
Attach the Lat Bar (60) to the High Cable (71) with a
Cable Clip (57). For some exercises, the Chain (58)
should be attached between the Lat Bar and the High
Cable with two Cable Clips. Adjust the length of the
Chain between the Lat Bar and the High Cable so
the Lat Bar is in the correct starting position for
the exercise to be performed.
The Nylon Strap (59) can be attached in the same
manner.
59
71
57
58
60
58
70
70
57
57
21
58
20
57
57
59
60
6
6. Slide the Weight Selector (47) and the Weight
(45) onto the Guide Tube (34).
7. Press a 2” Inner Cap (36) into the upper end of
the Main Upright (41). Press a 1 1/2” Inner Cap
(19) into the indicated location on the Main
Upright.
Attach the Main Upright (41) to the two 5/16” x
2 1/2” Carriage Bolts (35) in the Base (38) with
two 5/16” Nylon Locknuts (1).
Attach the Main Upright (41) to the Guide Tube
(34) with a 5/16” x 2 3/4” Bolt (7) and a 5/16”
Nylon Locknut (1).
Insert the 4” Weight Pin (50) under the seventh
Weight (45).
8. Attach the “V” Brace (42) to the Main Upright (41)
with the 5/16” x 3 1/4” Bolt (43), a 5/16” Flat
Washer (5), and a 5/16” Nylon Locknut (1). Do
not tighten the Nylon Locknut yet.
Attach the “V” Brace (42) to the Base (38) with
two 5/16” x 3/4” Bolts (76), two 5/16” Flat
Washers (5), and two 5/16” Nylon Locknuts (1).
Make sure that the Washers and Nylon
Locknuts are attached inside the Base.
Tighten all Nylon Locknuts used in this step.
Press two 2” Outer Caps (37) onto the Base (38).
6
45
34
Slot
Pin
Groove
7
36
1
19
45
34
38
1
35
41
76
42
43
37
37
38
41
1
5
1
1
5
5
7
8
50
47
To Next Page
Loading...
Need help?
General