whiskersupport.com
19
Reset Button + [Control Panel Lockout]
Press and Release:
When pressed while the Globe is at the Home position with the blue light on, it resets
the Cat Sensor.
When pressed during a cycle, it pauses the cycle. If pressed again while paused, it will
abort the cycle.
If pressed when the red light is on, it cancels the Wait Time and the unit returns to
standby (blue light on).
IMPORTANT: Any time you do anything that affects the weight or placement of the unit,
including adding or removing litter, emptying the Waste Drawer, or moving or cleaning
the unit, press the Reset button once you are done. The Reset button adjusts the Cat
Sensor automatically, ensuring the Litter-Robot will detect your cat and cycle properly.
Press and Hold: Activates Control Panel Lockout (see page 26), indicated by the blue
light blinking momentarily.
While in Control Panel Lockout mode, press and hold the Reset button to exit the mode,
indicated by the blue light blinking momentarily.
This setting will disable all button functions on the Control Panel while allowing the unit
to function normally in Automatic Mode. During Control Panel Lockout you can still turn
the unit off by pressing and holding the Power button for 3 seconds.
Reset Button
To Next Page
Loading...
Need help?
General
