4. Installation
Before using your wine cooler
Remove the exterior and interior packaging material
Stand the unit upright for approximately 2 hours before connecting to the power
source. This will reduce the possibility of a malfunction in the cooling system
from handling during transportation.
Clean the interior surface with a soft cloth and warm water.
Place your appliance on a floor that is strong enough to support the appliance
when it is fully loaded.
Do not place the appliance in direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources
may increase the ambient temperature and electrical consumption. Extreme
cold or hot ambient temperatures may also cause the appliance to malfunction.
Allow up to 24 hours of operation for the wine bottles to reach the desired
temperature.
Electrical Connection
This appliance should be properly grounded for your safety. The power cord of this unit is
equipped with a 3-pin plug to minimize the possibility of electrical shock. Do not under any
circumstances cut or remove the ground wine from the power cord supplied.
Use of extension cords is not recommended.
This unit requires a standard 110V-60HZ electrical outlet with 3-pin plug.
To prevent accidental injury, the power cord should be secured behind the wine refrigerator
and not left exposed or dangling.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
