5. Operations
Temperature Setting
It is recommended that you install the wine cooler in a place where the ambient temperature is
between (60- 80°F). If the ambient temperature is above or below recommended temperatures,
the performance of the unit may be affected. For example, placing in extreme cold or hot
conditions may cause interior temperature to fluctuate thus the set temperature may not be
achievable.
You can set the wine cooler temperature by pressing the “ ” and “ ” buttons on the control
panel.
Temperature settings for upper zone: 44ºF-66ºF (Left side control panel)
Temperature settings for lower zone: 50ºF-66ºF (Right side control panel)
Generally for red wines, the temperature range should be between 57ºF – 61ºF and for white
wines, the temperature range should be 50ºF - 54ºF. This is based on an ambient room
temperature of 77ºF.
Interior Light
You can turn on and off the interior light by pressing the “Light” button. The “Light” button on the
left side controls the upper zone light and the “Light” button on the right side controls the lower
zone light.
Handle Bars
Your wine cooler comes with a towel bar style handle. To install the handle, you will need a
Phillips-head screwdriver.
Open the door of the wine cooler.
Located the two screw holes on the inside of the door (they may be partially obscured by
the door seal so you may need to remove the door seal)
Insert the screws into the screw holes until they stick out of the front of the door.
Line up the holes in the handle with the screws and give each screw about 2-4 full turns
into the handle bar.
Now the turn the screws in all the way, and your handles are installed.
Replace seal into door frame.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
