Pro STAR Industries
1590-A N. Harvey Mitchell PKWY
Bryan, TX 44503
979-779-9399 1-800-262-7104
WAVE Instructions page 5
WAVE SET UP
1. Take machine out of storage position
by lowering onto all four wheels.
2. Adjust handle to comfortable position
at waist level by opening adjustment lever on
left side of machine and moving handle. Lock
back into position by closing adjustment lever.
3. Install cloth filter bag inside the main
body by pushing the rubber collar over the
chute.
4. Unzip the cloth bag and place the
paper bag inside. Push the rubber gasket seal
over the chute. Zip cloth bag closed taking
care not to damage the paper bag and close
lid.
5. Attach the detail tools to the top of the
dust bag cover by pressing the appropriate
tool into the clips.
6. Take the accessory wand and attach
to the hose and insert wand into the wand
holster.
7. Strain relief.
NOTE: Attach strain relief/cord retainer
to the power cord.
1. Make a loop in power cord
approximately
12” from receptacle end.
2. Slide cord loop through slot in retainer
arm. Pull slack cord back through slot to
secure. Attach retainer to handle.
To Next Page
Loading...
Need help?
General
