Worx landroid wg791E User Manual

Lawn Mowing Robot EN
17
Environmental Protection
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
Plug Replacement (UK & Ireland Only)
If you need to replace the fitted plug then follow the instructions below.
IMPORTANT
The wires in the mains lead are colored in
accordance with the following code:
Blue – Neutral
Brown – Live
As the colors of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in
your plug, proceed as follows. The wire which is coloured blue must be connected to the terminal which is marked with N. The wire which
is coloured brown must be connected to the terminal which is marked with L.
WARNING: Never connect live or neutral wires to the earth terminal of the plug. Only fit an approved BS1363/A plug and the
correct rated fuse.
NOTE: If a moulded plug is fitted and has to be removed take great care in disposing of the plug and severed cable, it must be destroyed
to prevent engaging into a socket.
Connect
Blue to N
(neutral)
Outer sleeve
firmly clamped
Cable grip
Brown L (live)
13 Amp fuse approved
to BS1362

Worx landroid wg791E Specifications

General

Type	Robotic lawn mower
Cutting width	180 mm
Cutting system	-
Recommended lawn area	1000 m²
Maximum cutting height	60 mm
Minimum cutting height	20 mm
Grass collecting volume	- L
Charging time	1.5 h
AC input voltage	28 V
Battery capacity	2 Ah
Cordless	Yes

Weight and Dimensions

Weight	- g