3. Manually winding the line (See Fig. N1, N2, N3, N4)
Take approximately 10ft (3m) of line. Insert 5/8 inch (15mm) of line into the Spool holes and wind line in the
direction of the arrows on the top of the Spool. Leave approximately 4 inches (100mm) of line unwound and place
into the cleat. Ensure that the line is neatly coiled on the Spool. Failure to do so will impair the efficiency of the
automatic line feed. Then fit the Spool as shown in Fig. M1, M2, M3
MAINTENANCE
After use, disconnect the battery from the tool and check for damage.
Your power tool requires no additional lubrication or maintenance. There are no user-serviceable parts in your
power tool. Never use water or chemical cleaners to clean your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry room temperature location. Keep the motor ventilation slots clean. Keep all working
controls free of dust.
For Battery tools
The ambient temperature range for the use and storage of tool and battery is 0 ºC-45 ºC. The recommended
ambient temperature range for the charging system during charging is 0 ºC-40 ºC.
TROUBLESHOOTING
The following table gives problems and actions that you can perform if your machine does not operate correctly. If
these do not identify and correct the problem, contact your WORX Customer Service at 1-866-354WORX.
WARNING: Switch the machine off and remove the battery prior to any troubleshooting.
To Next Page
Loading...
Need help?
General
