4
Charging the Pro+ Tool
The Pro+ Tool has a rechargeable battery. The tool takes approximately 2 hours to
charge from a fully depleted battery. Only use a DC Adapter that has the exact power
rating as the factory supplied charger. (15V / 1A). Any other Voltage rating could perma-
nently damage the tool and void the warranty.
When the Pro+ Tool battery is very low, the Low Bat Indicator light will illuminate.
When this happens you should plug into a power source soon. You can continue to use
the tool while it is charging. If the tool is powered on and charging, the battery life status
icon will animate. The Charging Indicator Light will also illuminate when the tool is
charging. Note that once the tool is fully charged the charge indicator light will no longer
illuminate. Always be sure to fully charge the Pro+ Tool before updating.
Tool Buttons and Layout
Powering On / O
Press and hold the power button for approximately 1 second to power ON or OFF the
Pro+ Tool. When powering the tool on you will see the Smart Sensor Pro+ Logo briey,
then the software version briey before seeing the main menu.
Back Button
Cancels certain operations or goes back 1 level in the tool menu.
Arrow Buttons
Move Selection or in between options.
Enter Button
Selects the highlighted option. Performs the function.
Smart Sensor Cradle
Hard contact point for programming Smart Sensor TPMS Sensors.
(powering on) (software version)
Arrow Buttons
Back Button
Enter Button
Power Button
Be sure to fully charge the Pro+ Tool the rst time you use it.
To Next Page
Loading...
Need help?
General