Installation
16 975-0171-01-01
3. Save your purchase receipt to use as proof-of-purchase. This is required if the
inverter/charger should need warranty service.
4. Save the original shipping carton and packing materials. If the inverter/
charger needs to be returned for service, it should be shipped in the original
carton. This is also a good way to protect the inverter/charger if it ever needs
to be moved.
Installation Tools and Materials
Tools You will need the following tools to install the RS3000 and the battery
temperature sensor.
p Wire stripper
p Crimping tools for fastening lugs and terminals on DC cables
p Phillips screwdriver: #2
p Slot screwdriver (¼" wide blade max.)
p Needle-nose pliers
p Wrench for DC terminals: 9/16"
Materials You will need the following materials to complete your installation:
p Strain-relief clamp(s) for AC cables: 3/4" and/or 1"
p DC battery cables sized according to Table 3 on page 14
p Terminals and/or crimp connectors for DC cables (for 3/8" stud size)
p Copper wire for DC grounding: No. 8 AWG. See “DC Grounding” on page 14
p Terminal or crimp connector for DC grounding cable (for 1/4" stud size)
p AC and DC disconnect switches and over-current protective devices and
connectors as required. See page 9 and page 13
p AC output and input wire. See Figure 2 on page 11
p If the AC ground wire is stranded, each ground wire requires a ring terminal
p Six 1/4"–20 1.25" length steel screws or bolts to mount the RS3000
For a list of tools and materials required to install the network, refer to the Xanbus
System Installation Guide, which is available for download at www.xantrex.com.
To Next Page
Loading...
Need help?
General