Powering Off the Press
Before you change toner color sets, power off the press. To power off the press, use the General Power
Off procedure.
GGeenneerraall PPoowweerr OOffff
Note: Before you power off the press, wait 5 seconds after any active job completes.
To power off the device, press the power On/Off button. For general use, to power on and power off
the press, press the power On/Off button. Do not use the main power switch to power on and power
off the press unless directed by a Xerox Service Representative.
When all print jobs have completed and there are no jobs currently processing, if you select the Power
Saver option, the press enters a reduced power-consumption mode.
Note: To reactivate the press when it is in Power Saver mode, press the Power Saver button.
PPoowweerriinngg OOffff tthhee MMaaiinn PPoowweerr
The main power switch controls the main power into the press. For normal press operation, leave the
main power on. Before connecting a cable, cleaning the press, or when a restart is required, press the
main power switch to the Off position.
Caution:
• Before unplugging the power cord, press the main power switch to the Off position. Failure
to do so can damage the press or cause a press malfunction.
• After you power on the press, wait a few seconds before you power off the main power.
Failure to do so can damage the press hard drive or cause a press malfunction.
• After you press the printer On/Off power button, wait a few seconds before you press the
main power switch to the Off position. Failure to do so can damage the press hard drive or
cause a press malfunction. After you power off the press, wait until the control panel touch
screen goes dark. Wait 10 seconds, then press the main power switch to the Off position.
Xerox
®
Adaptive CMYK+ Kit for the Xerox
®
Versant
®
180 Press
Accessory Reference Guide
11
Safety
To Next Page
Need help?
General
