88 4 Paper
Paper Sizes/ Paper Types of the Trays
If you loaded standard-size paper in the trays 1 - 4, set the size and orientation of the paper
in each paper tray using the paper size dial. If you loaded non-standard-size paper into the
trays 1 - 4, set the paper size dial to [
*
].
If you loaded non-standard-size paper into the bypass tray or trays 1 - 4, manually set its
paper size on the control panel.
The printer does not have ability to sense the type of the paper loaded in each tray. The
default paper types for the bypass tray or trays 1 - 4 are [Plain Paper]. If you loaded paper
other than plain paper into the trays, manually change its paper type on the control panel.
Make sure to set the paper type correctly on the control panel. If the paper type setting does
not match the actual type of the paper, toner may not fuse properly onto the paper, resulting
in smearing and poor print quality.
Note
• The paper type setting can be changed under [Paper Type] on the control panel. You can also change
the paper type from your print driver when requesting a print job.
• You can program your printer not to display a message asking you to change the paper type each time
you load paper into the paper trays. You can program this under [Display Screen] on the control panel.
Refer to
• For information on how to set the paper type setting on the control panel, refer to "Changing the Paper
Types of the Trays" (P. 89).
• For information on how to set a paper size on the control panel, refer to "Setting the Paper Sizes of the
Trays" (P. 90).
• For information about [Paper Type] and [Display Screen], refer to "[Paper Type]" (P. 125) and " [Display
Screen]" (P. 124), respectively.
• For information on how to set a paper type on your print driver, refer to " Printing by Changing the Paper
Type Setting" (P. 57).
Extending the Extension Output Tray
The extension output tray prevents printed
output from falling off the printer.
When printing documents, extend the extension
output tray.
To Next Page
Loading...
Need help?
General