Printer Settings
Phaser® 8560/8860 Printer
4-9
Paper Handling Settings
This section includes:
■ Selecting Tray 1 Mode on page 4-9
■ Selecting Tray 2–N Mode on page 4-10
■ Setting the Duration for the Tray 1 Prompt on page 4-12
■ Changing the Load Paper Timeout on page 4-13
Selecting Tray 1 Mode
The Tray 1 Mode setting specifies:
■ How Tray 1 paper type and size are determined when you load paper in the tray but do not
select the paper type and size on the control panel.
■ When Tray 1 is used for print jobs.
To select the Tray 1 mode setting, use one of the following options:
■ The printer’s control panel
■ CentreWare IS
Setting Description
Dynamic
(Factory default setting)
■ Uses the settings from the next print job that prints from Tray 1 to
determine the paper size and type.
■ Printer will print from Tray 1 when specified in the print job or when no
other tray has the job's requested paper size and type.
Static
■ The paper size and type already set for Tray 1 stay in effect.
■ Printer will print from Tray 1 when specified in the print job or when no
other tray has the job's requested paper size and type.
Automatic
■ Uses the settings from the next print job that prints from Tray 1 to
determine the paper size and type.
■ Printer will print from Tray 1 when paper is loaded, unless a different
tray is specified in the printer driver.