8
Replacing the Filter Daily Care & Maintenance
Plasma Generator
Warning: Make sure the purifier is turned off and the power cord is
unplugged before replacing the filter.
Notes:
·
To avoid injuries, do not put your fingers between the upper and
filter compartments when replacing the filter.
·
Unpack the new filter before replacing the old one.
Press and hold the
release buttons with
both of your hands
to separate the
upper compartment
from the filter
compartment.
Remove the old filter upwards and
place the new filter into the filter
compartment. Then reinstall the
upper compartment.
The dirt may rise in the air when
removing the old filter, and it is
recommended to wear gloves and a
mask before replacing the filter. Then
put the old filter into a plastic bag,
and secure the bag before discarding
it. If you come into physical contact
with dust, wash it off with water
instead of wiping it off.
Opening the filter
compartment
1
Replacing the filter
2
·
Open the plug, loosen the screw inside it with
a screwdriver, and rotate the grille clockwise
to remove it upwards.
·
Use a vacuum cleaner to remove any dust
from the air duct and fan blades, or wipe the
dust off gently with a soft cloth.
·
Use a brush or soft cloth to gently wipe the
plasma generator.
·
After cleaning, rotate the grille
counterclockwise to install it. Tighten the
screw with a screwdriver, and close the plug.
Cleaning fan blades and air duct
Note: To avoid damaging the purifier, do not rinse or spray
the air duct and fan blades directly with water, or wipe them
with a soaking wet cloth.
Warning: Make sure the purifier is turned off and
unplugged before performing the following operations.
Note: This purifier is compatible
with the model AFEP7TFX19 filter.
Align the filter with
the clip on the
purifier to install it.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
