15
Care & Maintenance
Parts
To keep the robot vacuum in good condition, it is recommended to refer to the following table for routine maintenance.
Note: The replacement frequency may differ based on actual conditions. If an error
occurs, the part involved should be replaced immediately.
Part
Maintenance
Frequency
Replacement
Frequency
Dust compartment Clean as required /
Filter in the dust
compartment
Clean every two weeks 3–6 months
Clean water tank Clean every two weeks
/Dirty water tank
Recommended to
clean after each use
Cleaning tray Clean every month
Brush Clean every two weeks 6–12 months
Side brush Clean every two weeks 3–6 months
Mop pad Clean every month 1–3 months
Omnidirectional wheel
Clean every month /
Edge sensor
LDS laser sensor
Line laser sensor
AI visual recognition
sensor
Ultrasonic sensor
Part
Maintenance
Frequency
Replacement
Frequency
Cliff sensor
Clean every month /
Omni station's
signaling area
Robot vacuum's
charging contacts
Omni station's
charging contacts
Bumper
Auto-empty vents of
robot vacuum
Robot vacuum's
automatic water
refilling inlet
Bottom of the robot
vacuum
Omni station
Auto-empty vents of
omni station
Omni station's air
outlet
Disposable bag / Replace as needed
To Next Page
Loading...
Need help?
General
