Hood hung prior to oven installation: Yes No
Hood hung to local codes: Yes No
All shroud panels properly installed: Yes No
Grease filters properly installed: Yes No
Grease trays properly installed: Yes No
Crumb trays easily removable: Yes No
Oven power cords connected to hood: Yes No
Oven switch cords connected to hood: YesNo
Lights operate: YesNo
Light globes installed over bulbs: YesNo
Exhaust fan purchased from XLT: YesNo
Correct fan rotation: YesNo
HUI properly programmed: YesNo
Smoke test performed: YesNo
Air balance test performed: Yes No
Notes:
Hood Initial Start-up Checklist - Remove & Return to XLT
Serial #:
Incoming power supplied:
Volts Amps
Hz Phase
Number of bends in duct run: _______45º ________ 90º
Height from bottom of hood to finished floor:
Inches
Length of duct run (from top of hood to fan):
Feet Inches
Exhaust fan serial #:
Rating of exhaust fan: CFM
Hood Size: 1832 2440 3240
3255 3270 3855
3870
Contact Information
Store Name: Address:
City: ____________________ State: _____ Zip:_______Phone #:
Email: ________________________________________Contact Person: ___________________________________
HVAC/Contractor Contact:_______________________Addr ess:
City: ____________________ State: _____ Zip:_______Phone #: _______________ Cell:
Email: _
Step 1: Fill out all information and print legibly
Step 2: Verify all information is correct before turning hood on
XLT
PO Box 9090
Wichita, KS 67277
FAX: 316-943-2769
Customer Signature: Date:
Installer Information
Date of installation: _______________________________________
Installed by:XLT Other______________________________
Company:_______________________________________________
Phone #:________________________________________________
Email:__________________________________________________
Customer or store operator shown how to disassemble and clean hood : Yes No
All hood features explained: Yes No
To Next Page
Loading...
Need help?
General