11
XT8
2. FRONT TRANSMISSION
930816
BB 8x16x5
901504
SB M5x4
Follow the TECH TIP on page 5
for drive shaft pin servicing.
908312
SCH M3x12
908312
SCH M3x12
902310
SH M3x10
901310
SB M3x10
During assembly, there is no need to check gear mesh or diff play. In particular, do not check gear mesh and diff play when the
differential is installed only in the gear box without the suspension holders and without being mounted to the chassis. All parts have
specifically designed play, and only when the car is fully assembled will it have the proper amount of play where necessary. Only
once you build the entire car, then you can check for free movement of all rotational parts and drivetrain as well a free non-binding
operation of suspension parts.
NOTE DIFF ORIENTATION
FRONT DIFF
10.000cSt
Graphite Grease
(HUDY #106210)
NOTE DIFF ORIENTATION
Cut on both front
and rear
bulkhead blocks.
DETAIL
➊
➋
➌
➍
➎
DETAIL
STEP DETAIL
➎
➎
Push joint against
gear to remove gap.
Tighten setscrew onto
gear flat spot.
XRAY BALL-BEARINGS
#930816 8x16x5 GREASE STEEL INCLUDED
#930817 8x16x5 OIL STEEL OPTION
Use HUDY Ball-Bearing Grease
#106220 - STANDARD
#106221 - BLUE
#106222 - RED
NOTE
ORIENTATION
3.5mm
2x
Bearing with STEEL covers.
Bearing with STEEL covers.
To Next Page
Loading...
Need help?
General
