1
Visit xtool.com/software to download and install
xTool Creative Space (XCS).
XCS
2
Turn on xTool F1, connect it to a PC, and then
connect it on XCS.
You can start your creation after connecting xTool F1 to XCS.
For details about how to use XCS to operate xTool F1 for material processing, visit support.xtool.com.
Connect device
Use software to operate xTool F1
Process small-sized materials
Multiple application scenarios
To cut a material, you are advised to use the triangular prism working panel. It can reduce the areas burned during
material processing and protect the baseplate.
Process large-sized materials Process materials with slopes
Turn the knob to move the laser module up and down. When the red and blue light spots coincide, the focus is successfully set.
Manual focus setting
When the bottom of the laser module reaches
the highest point, stop turning the knob up.
Using the infrared laser for bitmap engraving at a low temperature may lead to unsatisfying engraving results. To
ensure better engraving results, you can preheat the laser module before processing.
65
To Next Page
Loading...
Need help?
General
