To Next Page

To Previous Page

3. DIAGNOSTIC

The diagnostic application can read ECU information, read and clear DTC (Diagnostic Trouble Codes) and check live data

and freeze frame data. The Diagnostic application can access the ECU of various vehicle control systems, including the

Engine, Transmission, Anti-lock Braking System (ABS), Airbag Safety Restraing System (SRS), Electronic Parking Brake

system (EPB) and perform many types of actuation tests.

VEHICLE CONNECTION

The scan tool must be connected to the vehicle’s OBD-II port so that the tablet can establish correct vehicle communication.

Please perform the following steps:

1 Turn on the tablet

2 Connect vehicle and tablet via the main test cable

3 Switch on the ignition and tap on the Diagnostic application to start your diagnosis.

The connection method is shown in the figure below:

1. Vehicle

2. Main Cable (DB15

to OBD16)

3. Tablet

⚫ Precautions for Diagnosis

1. The voltage range on the car: +9~+18V DC;



Note: Please make sure all the cables are connected tightly; The vehicle’s DLC is not always located under

the dash; for the location of the DLC, please refer to the vehicle’s user manual.

Xtool IP608 User Manual

Questions and Answers: