Product Description
Products included
Pump model Approvals
2250.011 Standard
Pump design
The pump is submersible, and driven by an electric motor.
Intended use
The product is intended for moving waste water, sludge, raw and clean water. Always
follow the limits given in Application limits (page 36). If there is a question regarding the
intended use of the equipment, please contact an Xylem representative before
proceeding.
WARNING:
In explosive or flammable environments, only use Ex- or MSHA-approved pumps.
NOTICE:
Do NOT use the pump in highly corrosive liquids.
For information about pH, see Application limits (page 36).
Particle size
The pump can handle liquid containing particles that correspond to the holes in the
strainer.
Number of holes Hole dimensions
508 15×45 mm (0.6×1.77 in.)
Pressure class
MT Medium head
HT High head
Impeller type
B Wear resistant
Poly-Life
®
The pump is available with Poly-Life
®
polyurethane wear parts for extra resistance.
Monitoring equipment
The following applies to the monitoring equipment of the pump:
• The stator incorporates thermal contacts connected in series that activate the alarm at
overtemperature.
• The thermal contacts open at 125°C (257°F) and close at 95°C (203°F)
Product Description
Flygt 2250 Installation, Operation, and Maintenance Manual 9
To Next Page
Loading...
Need help?
General
