27 28
ATTENTION
●Do not park on soft ground or slope to prevent the scooter from
toppling over. You can use the main stand to support the
scooter for a long time.
●Turn off the power after parking, lock the anti-theft device, do
not put valuables in the scooter, do not forget to lock the seat
cushion and toolbox, and take away your belongings.
The side stand is located on the lower left side of the
scooter. When parking with the side stand, hold the
rear brake lever tightly with your left hand to prevent it
from moving, hold your right hand at the left side of
the passenger's armrest to keep the scooter vertical,
and then lower the side stand with your feet to tilt the
scooter to the left for parking.
1.Nut-type front wheel groups
2.15# open/box spanner
3.Torque: 160-250KGf.cm (16N.m-25N.m)/
4.Make sure wheel groups are at the
central position
1.Turn the M6 hexagon tool clockwise
2.Torque：100-120KGg.cm
9.8N.m-12N.m
3.Make sure the stem shares the
same direction with your riding.
4.ATTENTION: Safety line should
be folded or there may exist
potential risks.
1.Adjust the handlebar clamp to
assemble the handlebar. Please make
sure you can grip comfortably.
2.Please make sure the handlebar is in
parallel with the horizontal plane.
3.Please make sure there a 30-40
degree with the horizontal plane.
Side stand The assembly of the handlebar and stem
The assembly of the handlebar
Installation of the wheel
To Next Page
Loading...
Need help?
General
