Removing Memories from a Memory Bank
1. While operating in the Memory Bank mode, recall the memory channel to be re-
moved from a Memory Bank.
2. Press and hold in the
[
D/MR
(
MW
)]
key for one second, then press the
[
A/N
(
LOW
)]
key to remove the memory channel data from the Memory Bank.
You must rst enter the Memory Bank mode, by pressing the microphone’s
[
] key
, before attempting to remove a channel
from a Bank. If you don’t, “MCHERR” will appear when
you press the
[
A/N
(
LOW
)]
key in step
(
2
)
above.
Changing a Memory Bank’s Name
You may change the default Memory Bank Name, which is indicated on the display when
you’ve selected a Memory Bank, to a different name, if desired.
1. Press and hold in the
[
MHz
(
SET
)]
key for one second,
then rotate the DIAL knob to select “
9 BNK NM
”.
2. Press the
[
MHz
(
SET
)]
key momentarily, then rotate the
DIAL knob to recall the memory bank on which you
wish to change a label.
3. Press the
[
A/N
(
LOW
)]
key to enable changing of the
name tag.
4. Rotate the DIAL knob to select the rst digit of the de-
sired label.
5. Press the
[
A/N
(
LOW
)]
key to move to the next charac-
ter.
6. If you make a mistake, press the
[
REV
(
DW
)]
key to back-space the cursor, then
re-enter the correct letter, number, or symbol.
7. Repeat steps 4 through 6 to program the remaining let-
ters, numbers, or symbols of the desired label. A total of
six characters may be used in the creation of a label.
8. When you have programmed a name which is under 6
characters, press and hold in the
[
MHz
(
SET
)]
key for one second to conrm the label
and exit to normal operation.
36
Memory Operation
FT-2980R/E Operating Manual
To Next Page
Loading...
Need help?
General
