Yaesu FT-60R User Manual

FT-60R OPERATING MANUAL 41
“PRIORITY CHANNEL” SCANNING
(
DUAL WATCH
)
The FT-60R’s scanning features include a two-channel scanning capability which allows
you to operate on a VFO or Memory channel, while periodically checking a user-defined
Memory Channel for activity. If a station is received on the Memory Channel which is
strong enough to open the Squelch, the scanner will pause on that station in accordance
with the Scan-Resume mode set via Set Mode Item 35: RESUME. See page 35.
Here is the procedure for activating Priority Channel Dual Watch operation:
VFO Priority
1. Recall the memory channel you wish to use as the “Priority” frequency.
2. Now, set the radio to the VFO mode by pressing the
[
V/M
(
PRI
)]
key.
3. Press the
[
F/W
]
key, then press the
[
V/M
(
PRI
)]
key to activate the VFO Priority mode.
The display will remain on the VFO frequency, but every five
seconds the radio will check the Priority Channel (memory chan-
nel) for activity.
4. Press
[
F/W
]

[
V/M
(
PRI
)]
again to disable the VFO Priority mode.
Memory Channel Priority
1. Store the frequency you wish to be the “Priority” Channel into memory channel “1.”
2. Now, set the radio for operation on another memory channel.
3. Press the
[
F/W
]
key, then press the
[
V/M
(
PRI
)]
key to activate the Memory Priority
mode. The display will remain on the current memory channel
frequency, but every five seconds the radio will check the Prior-
ity Channel (memory channel “1”) for activity.
4. Press
[
F/W
]

[
V/M
(
PRI
)]
again to disable the Memory Priority mode.
When the Memory Bank feature is activated, the FT-60R will check the lowest memory
channel in the current Memory Bank as the priority channel.
HOME Channel Priority
1. Recall the memory channel you wish to use as the “Priority” frequency.
2. Now set the radio for operation on a HOME channel by pressing the
[
F/W
]
key fol-
lowed by
[
HM/RV
]
.
3. Press the
[
F/W
]
key, then press the
[
V/M
(
PRI
)]
key to activate
the HOME Priority mode. The display will remain on the HOME
channel frequency, but every five seconds the radio will check
the Priority Channel (memory channel) for activity.
4. Press
[
F/W
]

[
V/M
(
PRI
)]
again to disable the HOME Priority mode.
SCANNING

Yaesu FT-60R Specifications

General

Frequency Range TX	144-148 MHz, 430-450 MHz
Mode	FM
Antenna Impedance	50 Ohms
Dimensions	58 x 109 x 30 mm
Channels/Memory	1000 channels
CTCSS/DCS	Yes
Receiver Type	Double-Conversion Superheterodyne
Frequency Range RX	108-520 MHz, 700-999.99 MHz
Battery	7.2 V, 1400 mAh Ni-MH
Weight	370 g
Channel Steps	5, 10, 12.5, 15, 20, 25, 50, 100 kHz
Sensitivity	0.16 μV (12 dB SINAD)