FT-60R OPERATING MANUAL54
The FT-60R’s 16-button keypad allows easy DTMF dialing for Autopatch, repeater con-
trol, or Internet-link access purposes. Besides numerical digits
[
0
]
through
[
9
]
, the keypad
includes the
[
]
and
[
#
]
digits, plus the
[
A
]
,
[
B
]
,
[
C
]
, and
[
D
]
tones often used for repeater
control.
Manual DTMF Tone Generation
You can generate DTMF tones during transmission manually.
1. Press the
[
F/W
]
key, then press the
[
9
(
DTMF
)]
key to disable
the DTMF Autodialer, if necessary. The “CODE” indication will
appear in the display for a moment.
2. Press the PTT switch to begin transmission.
3. While transmitting, press the desired numbers on the keypad.
4. When you have sent all the digits desired, release the PTT switch.
DTMF Autodialer
Nine DTMF Autodial memories are provided, allowing you to store telephone numbers for
autopatch use. You can also store short autopatch or Internet-link access code streams so as
to avoid having to send them manually.
Here is the DTMF Autodial storage procedure:
1. Press the
[
F/W
]
key, then press the
[
0
( )
SET
]
key to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 17: DT WRT.
3. Press the
[
F/W
]
key momentarily to enable adjustment of this
Set Mode Item.
4. Rotate the DIAL knob to select the DTMF Memory register into
which you wish to store this DTMF string.
5. Press the
[
F/W
]
key momentarily to begin DTMF Memory en-
try into the selected register.
6. Rotate the DIAL knob to select the first digit of the DTMF string.
Selectable entries are 0 - 9, and A - F, with E and F representing
DTMF “*” and “#” tones respectively.
7. Press the
[
F/W
]
key to accept the first digit and move to the next digit of the DTMF
string.
8. Repeat steps 5 and 6 until you have completed the telephone
number.
9. If you make a mistake, press the
[
(
MHz
)]
key to move back to
the previous digit, then re-select the correct number.
10. If the telephone number made up of numbers only, you may key in the telephone
number directly from the keypad.
11. Press and hold in the
[
F/W
]
key for one second to save the set-
ting.
DTMF OPERATION
To Next Page
Need help?
General
