Information for Customers Operating Transceiver
in the UK on 5MHz (60m) and 70MHz* (4m)
Thank you very much for purchasing this YAESU HF transceiver.
The Transceivers listed in this notice are congured at the factory with the WRC-15 5MHz (60m) allocation as shown
below as “B2”.
When your Transceiver is operated in the UK, the 5MHz (60m) and 70MHz* (4m) conguration needs to be changed to
“C2” as shown below before using the transceiver for the rst time.
WRC-15 5MHz (60m) Band Frequency Range
Factory Default Conguration
“
B2
”
UK 5MHz (60m) and 70MHz* (4m) Band Frequency Range
Selectable Conguration
“
C2
”
5.351500 MHz - 5.366500 MHz
5.250000 MHz - 5.406500 MHz
70.000000 MHz - 70.499999 MHz*
* The 70MHz band is only available for the FTDX101MP, FTDX101D and FTDX10.
FTDX101MP / FTDX101D
1. Turn the transceiver OFF.
2. Press and hold in the
[
FUNC
]
and
[
MODE
]
buttons while
turning the transceiver ON.
The green LED Indicator will blink with intervals of 0.5 sec
(0.5 sec ON, 0.5 sec OFF).
3. Press and release the
[
MODE
]
button, and the Green LED
Indicator will now blink with interval of 1 sec (1 sec ON, 1
sec OFF).
4.
Press and hold in the
[
MODE
]
button, and the radio will re-
start automatically. Once restarted the change of 5 MHz
frequency configuration will have been completed suc-
cessfully.
Power Switch
FUNC Button
LED IndicatorMODE Button
FTDX10
1. Turn the transceiver OFF.
2. Press and hold in the
[
FINE
]
and
[
MODE
]
buttons while
turning the transceiver ON.
The green LED Indicator will blink with intervals of 0.5 sec
(0.5 sec ON, 0.5 sec OFF).
3. Press and release the
[
FUNC
]
knob, and the Green LED
Indicator will now blink with interval of 1 sec (1 sec ON, 1
sec OFF).
4.
Press and hold in the
[
FUNC
]
knob, and the radio will re-
start automatically. Once restarted the change of 5 MHz
frequency configuration will have been completed suc-
cessfully.
Power Switch
FINE ButtonFUNC Knob
LED Indicator MODE Button
To Next Page
Need help?
General
