SAFETY WHILE WORKING
GEN
INFO
1-4
E
3. Non-reusable items
Always use new gaskets, packings, O-
rings, split-pins, circlips, etc., on reas-
sembly.
DISASSEMBLY AND ASSEMBLY
1. Clean parts with compressed air when
disassembling.
2. Oil the contact surfaces of moving parts
before assembly.
3. After assembly, check that moving parts
operate normally.
4. Install bearings with the manufacturer’s
markings on the side exposed to view,
and liberally oil the bearings.
5. When installing oil seals, apply a light
coating of water-resistant grease to the
outside diameter.
To Next Page
Loading...
Need help?
General
