EasyManuals Logo
Home>Yamaha>Outboard Motor>9.9D

Yamaha 9.9D User Manual

Yamaha 9.9D
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
Operation
18
3. Secure the clamp bracket to the transom
using the bolts provided with the out-
board (if packed). For details, consult
your Yamaha dealer.
WARNING
EWM00650
Avoid using bolts, nuts or washers other
than those contained in the engine pack-
aging. If used, they must be of at least the
same quality of material and strength and
must be tightened securely. After tighten-
ing, test run the engine and check their
tightness.
EMU30172
Breaking in engine
Your new engine requires a period of break-in
to allow mating surfaces of moving parts to
wear in evenly. Correct break-in will help en-
sure proper performance and longer engine
life.
CAUTION:
ECM00800
Failure to follow the break-in procedure
could result in reduced engine life or even
severe engine damage.
EMU27050
Gasoline and engine oil mixing chart
(25:1)
CAUTION:
ECM00150
Be sure to mix gasoline and oil complete-
ly, otherwise the engine may be damaged.
EMU27073
Procedure for pre-mixed models
Run the engine under load (in gear with a pro-
peller installed) as follows.
1. First 10 minutes:
Run the engine at the lowest possible
speed. A fast idle in neutral is best.
2. Next 50 minutes:
Do not exceed half throttle (approximate-
ly 3000 r/min). Vary engine speed occa-
sionally. If you have an easy-planing
boat, accelerate at full throttle onto plane,
then immediately reduce the throttle to
3000 r/min or less.
3. Second hour:
Accelerate at full throttle onto plane, then
reduce engine speed to three-quarter
throttle (approximately 4000 r/min). Vary
engine speed occasionally. Run at full
throttle for one minute, then allow about
10 minutes of operation at three-quarter
throttle or less to let the engine cool.
4. Third through tenth hours:
Avoid operating at full throttle for more
than 5 minutes at a time. Let the engine
cool between full-throttle runs. Vary en-
gine speed occasionally.
5. After the first 10 hours:
Operate the engine normally. Use the
standard premix ratio of gasoline and oil.
For details on mixing fuel and oil, see
page 19.
1. : Gasoline
2. : Engine oil
U63V17E0.book Page 18 Thursday, February 26, 2004 11:52 AM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yamaha 9.9D and is the answer not in the manual?

Yamaha 9.9D Specifications

General IconGeneral
BrandYamaha
Model9.9D
CategoryOutboard Motor
LanguageEnglish

Related product manuals