2
Overview .......................................................................................................................... 3
Functionality enabled by connecting the DM1000 V2 to your video editor .................... 3
1. Make settings in your video editor ............................................................................ 4
2. Connect the DM1000 V2 to your video editor.......................................................... 4
3. Connect the DM1000 V2 to your video recorders .................................................... 5
4. Enable commands to be exchanged with the video editor ........................................ 6
5. Verify that the DM1000 is correctly connected to your video editor ........................ 7
6. Match the frame type with the video......................................................................... 8
7. Initialize the DM1000’s mixer settings ..................................................................... 9
8. Patch the INPUT jack signals to input channels........................................................ 9
9. Patch the bus signals to output jacks ....................................................................... 10
10. Assign the audio channel inputs for the video recorders and the DM1000 ......... 10
11. Specify the fader operation of the DM1000......................................................... 12
12. Specify the output destination (bus) for the signals input to the DM1000 .......... 13
12.1 If you are not using pre-read ................................................................................ 13
12.2 If you are using pre-read ...................................................................................... 14
13. Set the panning of the signals being input to the DM1000.................................. 14
14. Pair the input channels ......................................................................................... 15
15. Use the panel [SEL] LED to indicate the ESAM fader on/off status................... 16
16. Adjust the input/output levels .............................................................................. 16
17. Specify the delay for the input channels .............................................................. 17
18. Store the scene memory ....................................................................................... 17
19. Controlling the system from your video editor.................................................... 17
To Next Page
Loading...
Need help?
General
