Yamaha F225 - Engine Power Loss and Emergency Actions

Maintenance
96
4. Remove the gear oil drain screw and
gasket.
5. Remove the oil level plug and gasket to
allow the gear oil to drain completely.
NOTICE: Check the used gear oil after
it has been drained. If the gear oil is
milky or contains water or a large
amount of metal particles, the gear
case may be damaged. Have a
Yamaha dealer check and repair the
outboard motor.
[ECM00714]
TIP:
For disposal of used gear oil, consult your
Yamaha dealer.
6. Remove any metal particles on the mag-
netic gear oil drain screw. NOTICE: If
there is an excessive quantity of met-
al particles on the magnetic gear oil
drain screw, this can indicate lower
unit problem. Consult your Yamaha
dealer.
[ECM01901]
7. Place the outboard motor in a vertical
position. Using a flexible or pressurized
filling device, inject the gear oil into the
gear oil drain screw hole.
1. Cooling water inlet cover
2. Bolt
1. Gear oil drain screw
2. Gasket
1
1
2
ZMU07189
1
2
ZMU07190
1. Oil level plug
2. Gasket
12
ZMU07191
6CE-9-36-1E0.book 96 ページ ２０１４年１１月２８日 金曜日 午後２時５５分
©2019 Yamaha Motor Corporation, U.S.A.