Operation
73
2. Pull the tilt lock lever up to the release
position.
3. Slightly tilt the outboard motor up to the
desired position and push the tilt lock le-
ver down to the lock position.
4. To return the outboard motor to the nor-
mal running position, pull the tilt lock le-
ver up to the release position and slowly
tilt the outboard motor down.
5. Push the tilt lock lever down to the lock
position.
EMU32852
Power trim and tilt models
The outboard motor can be tilted up partially
to allow operation in shallow water.
ECM00261
Do not tilt the outboard motor up so that
the cooling water inlet on the lower unit is
above the surface of the water when set-
ting up for and cruising in shallow water.
Otherwise severe damage from overheat-
ing can result.
EMU32914
Procedure for power trim and tilt models
1. Place the remote control lever / gear
shift lever in neutral.
2. Slightly tilt the outboard motor up to the
desired position using the power trim
and tilt switch. WARNING! Using the
power trim and tilt switch on the bot-
tom cowling while the boat is moving
or engine is on could increase the
risk of falling overboard and could
distract the operator, increasing the
risk of collision with another boat or
an obstacle.
[EWM01851]
N
ZMU01771
6BG-9-3F-E0.book 73 ページ ２０１８年１１月１日 木曜日 午後５時１分
©2020 Yamaha Motor Corporation
To Next Page
Need help?
General
