Setting Up
MG10/2
22
• When using the mixer on a microphone stand, be
sure to set the stand on a level and stable surface.
Do not set up the stand in locations subject to
vibrations or wind.
• Note that mixer may be damaged if the stand
should fall over. Attach the connection cables care-
fully so that the cables will not catch on the equip-
ment and cause it to fall. For example: arrange the
cables so that they run parallel with the micro-
phone pole down to the base of the stand.
• Leave ample free space around the stand.
(1) Turn the mixer upside-down, and hold the microphone-stand
adaptor (BMS-10A; sold separately) against the bottom of the
mixer so that the screw holes are aligned (1).
Screw the adaptor firmly into place with the two screws (2).
(2) Turn the mixer right-side up, and mount it onto your micro-
phone stand.
(3) Loosen the angle adjustment wingnut (1), adjust the mixer’s
angle as desired (2), and then tighten the wingnut securely (3).
For more information, refer to the BMS-10A Owner’s Manual.
Mounting to a Microphone Stand
1
2
1
3
2
To Next Page
Loading...
Need help?
General
