RX-V350/HTR-5730
30
RX-V350/HTR-5730
14. SOFT SW
This menu is used to switch the function settings on the
P.C.B. through the software so as to activate the product.
The protection function follows the P.C.B. settings. When
connected to AC or in the maker preset state, the unit is
initialized to the P.C. B. setting. Display of each function
after initialization varies depending on settings on P.C.B.
The operation mode can be changed by selecting the sub-
menu and then using the EFFECT key. With SOF selected
for the SW mode, the settings become effective.
MODEL SETTING: V350 or V350T can be selected.
As there is no model to replace with, this mode is used the
check for the T destination.
TUNER DESTINATION: UC, AKGTE or RL can be
selected.
SW MODE: PCB or SOFT can be selected.
ZONE2: NOT or EXIST can be selected.
(Not applied to these models.)
RDS: NOT or EXIST can be selected.
VIDEO FORMAT: NTSC or PAL can be selected.
(Not applied to these models.)
TUNER: NOT or EXIST can be selected.
13. SD DL CODE
This menu is used to display the data version of the
FLASH ROM, TOC information and sum calculated
value for the second decoder.
TA 0-5
Displays the TOC information.
SA 0-5
Displays the sum calculated value.
RDV
Displays the data version.
To Next Page
Loading...
Need help?
General
