model no. 060-1981-4 | contact us: 1.866.523.5218model no. 060-1981-4 | contact us: 1.866.523.5218
14
ASSEMBLY
1. OPEN THE LOWER HANDLE AND ADJUST THE HANDLE HEIGHT
1) Pull the lower handle lock knob out a little. Turn the lower handle lock knob to about 90
o
position. (See Fig. A1.)
2) Select a required hole from the 3 holes on the deck. Open the lower handles from
transportation position. Align the hole on the lower handle and the selected hole.
(See Fig. A2.)
NOTE: The 3 holes are used for adjusting the handle height. Select an appropriate hole as required.
To reduce the risk of injury, user must read instruction manual
Intended Use
This product is intended for domestic lawn mowing.
•
Mowing with grass collection bag attached - Standard lawn mowing with grass collection
bag attached.
•
Mowing with side discharge chute attached - use the side discharge chute instead of
grass collection bag, and grass clippings are ejected from the mower on the right hand
side of the deck.
•
Mulch and mowing - use the mower with mulching block instead of grass collection bag
attached. The lawn mower will mulch as it cuts and the ne grass clippings are distributed
back onto the grass surface without leaving piles of grass clippings.
Assembly
CAUTION! The machine must not be put in operation before it has been
assembled completely.
CAUTION! Do not insert the battery until the appliance has been completely
assembled.
1
2
A2
A1
To Next Page
Need help?
General
