1. Pull the hookswitch tab in the handset cradle.
2. Rotate the hookswitch tab 180 degrees.
3. Reinsert the hookswitch tab.
The hookswitch tab has a lip which allows the handset to
stay on-hook when the IP phone is mounted vertically.
To adjust the hookswitch tab:
Adjust the hookswitch tab as shown below(Take a
SIP-T21P IP phone as an example):
Wall Mount Quick Installation Guide
for SIP-T23_T22_T21_T20_T19 IP Phones
This quick installation guide provides step-by-step
instructions for mounting your IP phone to a wall.
SIP-T19(P) IP Phone
www.yealink.com
Wall mount is avaliable for the following IP phones:
SIP-T22(P) IP Phone
Wall Mount Quick Installation Guide
180
。
Adjusting the Hookswitch Tab
The IP phone is packaged with the hookswitch tab in
desk mount position. Before mounting the IP phone to
a wall, you must set the hookswitch tab to wall mount
position.
SIP-T21(P) IP Phone
SIP-T20(P) IP Phone
Depending on which model you own, your IP phone can
be mounted to the wall in one of two ways:
By using the stand(included with SIP-T23P/T23G/T22(P)
/T21(P)/T21(P) E2 /T20(P) IP phone)
By using the slots on the back of the phone
(for SIP-T19(P)/T19(P) E2 IP phone)
Screws, wall anchors and applicable tools are also
required for wallmount installation. These are not
included with your IP phones. You need to purchase
them separately.
SIP-T23P/G IP Phone
SIP-T21(P) E2 IP Phone
SIP-T19(P) E2 IP Phone
To Next Page
Need help?
General
