Administrator’s Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones
64
Parameter
static.network.qos.audiotos
[1]
<y0000000000xx>.cfg
Description
It configures the DSCP (Differentiated Services Code Point) for voice packets.
The default DSCP value for RTP packets is 46 (Expedited Forwarding).
Permitted
Values
Integer from 0 to 63
Default
46
Web UI
T57W/T54W/T53W/T53/T48U/T46U/T43U/T42U:
Network > Advanced > QoS > Voice QoS (0~63)
Other Phones:
Network > Advanced > Voice QoS > Voice QoS (0~63)
Parameter
static.network.qos.signaltos
[1]
<y0000000000xx>.cfg
Description
It configures the DSCP (Differentiated Services Code Point) for SIP packets.
The default DSCP value for SIP packets is 26 (Assured Forwarding).
Permitted
Values
Integer from 0 to 63
Default
26
Web UI
T57W/T54W/T53W/T53/T48U/T46U/T43U/T42U:
Network > Advanced > QoS > SIP QoS (0~63)
Other Phones:
Network > Advanced > Voice QoS > SIP QoS (0~63)
[1]
If you change this parameter, the phone will reboot to make the change take effect.
802.1x Authentication
Yealink phones support the following protocols for 802.1x authentication:
l EAP-MD5
l EAP-TLS (requires Device and CA certificates, requires no password)
l EAP-PEAP/MSCHAPv2 (requires CA certificates)
l EAP-TTLS/EAP-MSCHAPv2 (requires CA certificates)
l EAP-PEAP/GTC (requires CA certificates)
l EAP-TTLS/EAP-GTC (requires CA certificates)
l EAP-FAST (supports EAP In-Band provisioning, requires CA certificates if the provisioning method is Authentic-
ated Provisioning)
For more information on 802.1x authentication, refer to Yealink 802.1X Authentication.
Topic
802.1x Authentication Configuration
802.1x Authentication Configuration
The following table lists the parameters you can use to configure 802.1x authentication.
Parameter
static.network.802_1x.mode
[1]
<y0000000000xx>.cfg
Description
It configures the 802.1x authentication method.
Permitted
0-EAP-None, no authentication
To Next Page
Loading...
Need help?
General
