YTMC-51N2-M3 MoCA 2.5 Adapter
10
Coaxial Cable
If applicable, the coaxial cable screen shield needs to be connected to the Earth at
the building entrance per ANSI/NFPA70, the National Electrical Code (NEC), in
particular Section 820.93, “Grounding of Outer Conductive Shield of a Coaxial
Cable,” or in accordance with local regulation.
FCC Class B Equipment
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try and correct the
interference by implementing one or more of the following measures:
•
Reorient or relocate the device;
•
Increase the separation between the equipment and receiver;
•
Connect the equipment to an outlet on a circuit different from that to which
the receiver is connected (applicable only to power line products);
•
Consult the dealer or an experience radio or television technician for help.
Declaration of Conformity for Products Marked with
the FCC logo–USA Only
This device complies with Part 15 of the FCC Rules license-exempt RSS standard(s).
Operation is subject to the following two conditions:
1.
This device may not cause harmful interference;
2.
This device must accept any interference received, including
interference that may cause undesired operation of the device.
CE
EN 55032: Electromagnetic compatibility of multimedia equipment -Emission
requirements
EN 55035: Electromagnetic compatibility of multimedia equipment - Immunity
requirements
To Next Page
Loading...
Need help?
General