REPLACING YAP1F REMOTE CONTROL BATTERIES
AND NOTES
M
I
N
I
S
P
L
I
T
S
•
V
R
F
•
P
T
A
C
•
S
O
L
A
R
•
L
E
D
L
I
G
H
T
I
N
G
Your Modern Green Idea
7
YMGI Group • 601 Arrow Ln, O’Fallon, MO 63366 • info@ymgigroup.com • ymgigroup.com • 866-833-3138
1. Lift the cover along the direction of arrow (as shown in Fig 1).
2. Take out the original batteries (as shown in Fig 1).
3. Place two 7# (AAA 1.5V) dry batteries, and make sure the position of “+” polar and “-” polar is correct (as
shown in Fig 2).
4. Reinstall the cover (as shown in Fig 2).
Notes:
1. The remote controller should be placed 1m away from the TV set or stereo sound sets.
2. The operation of remote controller should be performed within its receiving range.
3. If you need to control the main unit, please point the remote controller at the signal receiving window of
the main unit to improve the receiving sensibility of main unit.
4. When the remote controller is sending signal, “” icon will blink for 1 second. When the main unit receives
valid remote control signal, it will give out a sound.
5. If the remote controller does not operate normally, please take the batteries out and reinsert them after 30
seconds. If it still can’t operate properly, replace the batteries.
6. When replacing the batteries, do not use old or different types of batteries, otherwise, it may cause
malfunction.
7. When the remote controller will not be used for a prolonged period of time, please remove the batteries.
Fig.1 Fig.2
To Next Page
Loading...
Need help?
General
