Residential Air Handler
with Electric Heat Start-Up Sheet
Proper start-up is critical to customer comfort and equipment longevity
Other Jumpers
(Check all that apply)
Equipment Data
Blower Type
&
Set-Up
A B C D
A
B
C D
Total external static pressure
Supply Return
Condensate drain properly connected per the installation instructions Condensate trap has been primed with water
Duct connections are complete:
Number of filters Filter size
Unit is level
Filters installed
Retrofit
New Construction
Down flow
Up flow Horizontal Left
Horizontal Right
Ground connected
Start-Up TechnicianCompany Name
208 volts AC 230 volt AC
Line Voltage Measured (Volts AC)
Supply static (inches of water column)
Supply air dry bulb temperature
Return air dry bulb temperature
Temperature drop
1 2 3 4 5
Low Medium Low Medium Medium High High
A B C D
Outside air dry bulb temperature
Return air wet bulb temperature
Supply air wet bulb temperature
Return static (inches of water column)
Electrical Connections & Inspection (Complete all that apply)
Continued on next Page
ECM
X-13
PSC
A
B
C D
Low voltage value between "R" and "C" at control board (Volts AC)
Thermostat wiring is complete Thermostat cycle rate or heat anticipator adjusted to Installation Manual specifications
AC
HP
ML
H
NOYES
Equipment Data
Air Flow Setup
COOL
ADJUST
DELAY
HEAT
HUM STAT
AC/HP
CONT FAN
Name Address
City State or Province Zip or Postal Code
Daytime Phone
Unit Model # Unit Serial #
Transformer wired properly for primary supply voltageInspect wires and electrical connections
Unit Location and Connections (Check all that apply)
General Information (Check all that apply)
Start-Up Date
Filters
Owner Information
To Next Page
Loading...
Need help?
General
