EasyManuals Logo
Home>York>Thermostat>S1-THSU32P7

York S1-THSU32P7 User Manual

York S1-THSU32P7
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #45 background imageLoading...
Page #45 background image
Page 37
TroubleShooting
SYMPTOM: The air conditioning does not attempt to turn on.
CAUSE: The cooling setpoint is set too high.
REMEDY: Lower the cooling setpoint or lower the cooling set-
point limit. See Setpoint Limits (page 22).
SYMPTOM: The air conditioning does not attempt to turn on.
CAUSE: The compressor timer lockout may prevent the air
conditioner from turning on for a period of time.
REMEDY: Consult the Owner's Manual in the Installer Setup
section to defeat the Cycles Per Hour (page 22).
I
Am
Outdoor
COOL SET
HEAT ETS
2:00
78
74
68
85
MO
YOUR NAME
COOLER MODE WARMER
SYMPTOM: The display is blank.
CAUSE: Lack of proper power.
REMEDY: Make sure the power is on to the furnace and that
you have 24vac between R & C.
I
Am
Outdoor
COOL SET
HEAT ETS
2:00
78
74
68
85
MO
YOUR NAME
COOLER MODE WARMER
I
Am
Outdoor
COOL SET
HEAT ETS
2:00
78
74
68
85
MO
YOUR NAME
COOLER MODE WARMER
SYMPTOM: The heating does not attempt to turn on.
CAUSE: The heating setpoint is set too low.
REMEDY: Raise the heating setpoint or raise the heating set-
point limit. See Setpoint Limits (page 22).
I
Am
Outdoor
COOL SET
HEAT ETS
2:00
78
74
68
85
MO
YOUR NAME
COOLER MODE WARMER
SYMPTOM: When controlling a residential heat pump, and
asking for cooling, the heat comes on.
CAUSE: The thermostat reversing valve jumper is set for “B”.
REMEDY: Set the reversing valve jumper for “O”.
I
Am
Outdoor
COOL SET
HEAT ETS
2:00
78
74
68
85
MO
YOUR NAME
COOLER MODE WARMER
SYMPTOM: When calling for cooling, both the heat and cool
come on.
CAUSE: The thermostat equipment jumper is configured for
“HP” and the HVAC unit is a Gas/Electric.
REMEDY: Set the equipment jumper for “Gas”.
I
Am
Outdoor
COOL SET
HEAT ETS
2:00
78
74
68
85
MO
YOUR NAME
COOLER MODE WARMER
SYMPTOM: When the Program button is pressed, the display
reads “DISABLED”.
CAUSE: Program mode is set to “NON PROGRAM”.
REMEDY: Set Program Mode (Setup 1) to 1, 5/2, or 7 Day.
See Selecting Your Program Mode (page 21).
I
Am
Outdoor
COOL SET
HEAT ETS
2:00
78
74
68
85
MO
YOUR NAME
COOLER MODE WARMER

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the York S1-THSU32P7 and is the answer not in the manual?

York S1-THSU32P7 Specifications

General IconGeneral
BrandYork
ModelS1-THSU32P7
CategoryThermostat
LanguageEnglish

Related product manuals