5
Release the lock-
ing system to remove
the internal panel of
glass.
90°
6
Turn the two fas-
teners by 90° and re-
move them from their
seats.
1
2
7
Carefully lift (step
1) and remove (step
2) the panel of glass.
Clean the glass panel with water and soap. Dry
the glass panel carefully.
Installing the door and the glass panel
When you install the panel with a decorative
frame, make sure that the screen-printing zone
looks to the inner side of the door. Make sure
that after the installation the surface of the
glass panel frame on the screen-printing zones
is not rough when you touch it.
Make sure that you install the internal panel of
glass in the seats correctly (refer to the illustra-
tion).
What to do if…
Warning! Refer to the Safety chapters.
Problem Possible cause Remedy
The appliance does not heat up. The appliance is deactivated. Activate the appliance. Refer to
"Daily use".
The appliance does not heat up. The fuse in the fuse box is re-
leased.
Do a check of the fuse. If the fuse
is released more than one time,
contact a qualified electrician.
The oven lamp does not operate. The oven lamp is defective. Replace the oven lamp.
Steam and condensation settle on
the food and in the appliance.
You left the dish in the appliance
for too long.
Do not let the dishes stay in the
appliance for more than 15-20
minutes after the cooking ends.
If you cannot find a solution to the problem
yourself, contact your dealer or the service
centre.
The necessary data for the service centre is on
the rating plate. The rating plate is on the front
frame of the oven cavity.
We recommend that you write the data here:
13
www.zanussi.com
To Next Page
Loading...
Need help?
General
