To Next Page

To Previous Page

read voltage, current and temperature. The following definition listing shows the

relative measurements:

1) MOTOR VOLTAGE

This is the voltage supplied to the motor by the inverter; it is expressed as a

percentage of the full voltage (which depends of the battery voltage).

2) FREQUENCY

This is the frequency of the voltage and current supplied to the motor.

3) ENCODER

This is the speed of the motor, expressed in the same unit of the frequency;

this information comes from the speed sensor.

4) SLIP VALUE

This is the difference of speed between the rotating field and the shaft of the

motor, expressed in the same unit of the frequency.

5) CURRENT RMS

Root Mean Square value of the motor current.

6) TEMPERATURE

The temperature measured on the aluminium heat sink holding the MOSFET

devices.

7) MOTOR TEMPERAT.

This is the temperature of the motor; if the option is programmed "None" (see

chapter 5.4.1) it shows 0°.

8) ACCELERATOR

The voltage of the accelerator potentiometer's wiper (CPOT). The voltage

level is shown on the Left Hand Side of the Console Display and the value in

percentage is shown on the Right Hand Side.

9) FORWARD SWITCH

The level of the Forward direction digital entry FW.

- ON / +VB = active entry of closed switch.