Zebra GC420t User Guide COBISS System Management
10/23 © IZUM, 21. 1. 2014, VIF-NA-26-EN, V1.0
5 Maintenance procedures
5.1 Calibrating label length
Once the media roll is placed and the transfer ribbon is loaded, go through the following steps.
Make sure that the printer's cover is closed and the status light is green (see Figure 14 and Table
1).
1. Turn off the printer.
2. Press and hold the FEED button.
3. Turn on the printer.
4. The status light flashes red. Wait for the light to turn green and release the FEED button.
5. The printer starts calibrating. The text Now in DUMP… is printed on the label, and the
media roll starts moving forward. Once the process is finished, the text Out of DUMP is
printed on the label.
Figure 14: Calibrating label length
To Next Page
Loading...
Need help?
General
